Search

315 NMHC Cutter

Product Description

Signal Group’s 315 NMHC cutter provides the capability to measure methane and non-methane hydrocarbons only for clients with a standard heated flame ionisation detector (FID).

An external non-methane hydrocarbon cutter provides capability to measure methane only for clients with a standard heated flame ionisation detector (FID). The Model 315 provides a low cost alternative to “all in one” FIDs with a built in cutter.

Housed in a 19” rack-mount case suitable for inline usage with portable and fixed equipment, this unit is ideal for use with 3010 or SOLAR FID units. Two modes of operation allow a reading for either total hydrocarbons or methane only, allowing you to derive a value for nonmethane hydrocarbon concentration.

Signal Group’s 315 NMHC cutter provides the capability to measure methane and non-methane hydrocarbons only for clients with a standard heated flame ionisation detector (FID).

An external non-methane hydrocarbon cutter provides capability to measure methane only for clients with a standard heated flame ionisation detector (FID). The Model 315 provides a low cost alternative to “all in one” FIDs with a built in cutter.

Housed in a 19” rack-mount case suitable for inline usage with portable and fixed equipment, this unit is ideal for use with 3010 or SOLAR FID units. Two modes of operation allow a reading for either total hydrocarbons or methane only, allowing you to derive a value for nonmethane hydrocarbon concentration.

Documentation

➔ Ancillary Equipment Brochure

➔ Datasheet

Technical Specification

EFFICIENCY: >98%

CATALYST TEMPERATURE: <300ºC

CALIBRATION SOLENOID TEMPERATURE: 200ºC

HEATED FILTER TYPE: Quick release via rear panel. Hydrocarbon free. Fibreglass 0.1 micron. Heated to 200ºC

MAINS VOLTAGE: 220V/240V/50Hz 110V/120V/60Hz

POWER: <300W

CONVERTER CHAMBER: Fully heated

GAS CONTACT MATERIALS: 316 stainless steel

CHAMBER TEMPERATURE: Factory preset

TEMPERATURE CONTROL: PID control

GAS CONNECTIONS: 1/4” stainless steel

SAMPLE FLOW: 3 litres/min

FILTER TYPE: Stainless steel sintered disk

AVERAGE FILTER PORE SIZE: 100 micron

CHANGEOVER VALVE: Electric valve

MAX INLET THC CONCENTRATION: 2000ppm propane equivalent

WARM UP TIME: Average 60 minutes

WEIGHT: 6kg