The 200SM Series of 19″ rack mounting cooler dryers remove water vapour from Stack and Exhaust Emission gases, before analysis by ambient analysers. Errors due to water interference are removed and condensation is prevented from occurring inside the analysers. The unit is based on a solid state Peltier cooler element with a continuous peristaltic pump which removes the unwanted water.
Key Features
• Available in 1, 2 or 3 channel configurations
• Switchable 115/230 Vac.
• Solid state cooler element
• Front panel status indicators
• Compatible with all gas analysers
• Temperature and water alarm for each channel
• High inlet temperature up to 210oC
• High capacity – up to 9 l/min
• Ambient temperature up to 40oC
Technical Specification
INLET:
Maximum inlet temperature: 210oC
OUTLET:
Sample:
dewpoint 5oC ± 0.5oC
Hot air:
exhausted to ambient
Condensate:
pumped to drain
FLOW RATE:
3 l/min (maximum) per channel
PLUMBING:
Gas sample(s):
1/4” tube fittings
Condensate drain:
1/4” stainless steel
POWER:
Voltage rating:
115 Vac or 230 Vac ± 15% switchable on rear panel
Consumption:
90 VA + 90 VA per channel (maximum)
ENVIRONMENT:
Ambient temperature range: + 5oC – 40oC
Max Humidity: 95% RH non-condensing
FRONT PANEL:
Mains power on/off switch
Each channel has the following LED indicators:
– Status (green)
-High temperature alarm (red)
-Low temperature alarm (red)
-Water alarm (red)
-Power (green)
ALARMS:
Each channel has three alarms:
-High temperature
-Low temperature
-Water condensate present
Each channel has one alarm output relay. Each alarm output relay has two independent sets of change over contacts.
DIMENSIONS:
19” rach mounting 5U high
Depth behind mounting panel: 533mm
Protrusion in front of: 45mm
Height: 222mm
Width: 435mm
WEIGHT:
10kg + 5kg per channel
