Sample Handling
Signal’s sample handling modules and components condition gas samples in preparation for analysis.
Signal’s sample handling modules and components condition gas samples in preparation for analysis.
Within the field of gas analysis much time is spent looking at the accuracy and uncertainty in the detection technique. However, without appropriate sample handling, what you are measuring could potentially bear little or no relation to your original sample.
Signal manufacture our own range of sample handling components including chillers with minimal condensate contact to limit and loss of soluble species, heated transfer lines to prevent condensation, probes to ensure representative samples are obtained, plus various filters to protect expensive and delicate analysis modules.
Signal Group’s sample handling modules and components condition gas samples in preparation for analysis. Imperial or metric sizes with various insertion lengths. Signal Group offer...
Signal Group’s sample handling modules and components condition gas samples in preparation for analysis. 1/8”, ¼”, 3/8” and ½” versions, and their metric equivalents (3mm,...
Suitable for use with both PULSAR and AURORA analysers. With the ability to connect up to 5 sample pumps to a single Pulsar gas analyser...
The 363SM is a heated pre-filter which is installed close to the sampling point, providing a filtration of hot sample gas before allowing down the...
A light duty, portable heated pump and pre-filter unit for use with single heated instruments. Provides variable inlet pressures and sample flow rates for very...
A medium duty heated Prefilter unit is installed in the 19" Rack housing of the analysers. The Prefilter is fitted with a choice of either...
The Front End Filter (FEF) module is a prefilter which is installed close to the sampling point, providing sample filtration and system integrity checking with...
The Signal Group 250 Portable cooler dryer removes water vapour from stack and exhaust emission gases, before analysis by ambient analysers.
The 200SM Series of 19″ rack mounting cooler dryers remove water vapour from Stack and Exhaust Emission gases, before analysis by ambient analysers. Errors due...